#Samsung washing machine how to#

Overloading and using the wrong detergent which cause foaming can also lead to leaking. Also check where the drain hose fits into the drainage system. Make sure the door is closed properly and the hose connections are tight. Cleaning the screens on the hoses can help if it is stopping water getting through. You should check your hot water tap temperature and make sure that it is not too hot nor too cold.

Also make sure the hoses are connected correctly. Make sure you have both faucets fully open and your temperature selection is correct. Washer is filling up with the wrong water temp You should always check filters and hoses occasionally to remove any blockages. There may be a pause before your washer begins to cycle once it fills. Close and open the door and press the start/pause button. Also check the fuse and the circuit breaker on your electrical board. The washer has stopped workingĬheck the power by plugging the cord into a live outlet. If this doesn’t work then try opening and closing the door and pressing the start/pause button again. The hose filter screens could also be blocked.

If there is a kink or blockage in the inlet hoses, that might stop water getting in. This could be because the faucets aren’t turned on or the door is not closed properly. Any other resolution will need a qualified engineer. If these aren’t the problem then there may be an issue with the fuse – in which case you need to reset the circuit breaker. Ensure the water faucets are on open and press the start/pause button. Check that the door is closed properly and your washer is plugged in. If there is a problem with the drain restriction, you may need to get an engineer in.

#Samsung washing machine how to#

Check your manual for instructions on how to remove and give it a rinse under the kitchen tap. Check the filter isn’t clogged up with debris. First of all, check the drain hoses and make sure they are not blocked or kinked. If this doesn’t work, then there may be an issue with the door latch itself which will require an engineer. If it’s still going through the heating cycle the door will not open but should disengage a few moments after. You can press the start/pause button to stop the washer. This usually happens when you are in mid-cycle. Most problems can be handled quite easily with a little know how but if you are unsure you should always get a qualified engineer in to diagnose and fix your machine. Samsung Washing Machine Problems and Troubleshootingīelow you will find the common problems and troubleshooting solutions associated with most front-loading Samsung washing machines.